Hacking Windows 10 and Windows 7 Using DigiSpark

Hacking Windows 10 and Windows 7 Using DigiSpark

image description

What you will learn

What is DigiSpark DigiSpark Programming How DigiSpark can be used in Hacking Hacking Windows 10 and Windows 7 Based System using DigiSpark Port Forwarding WAN Attack (Attack on Different Public IP's)


Section 1: Introduction

Section 2: Setup IDE

Section 3: Introduction to DigiSpark Programming

Section 4: Hacking Windows 10 on LAN

Section 5: Hacking Windows 7 on WAN

Section 6: Bonus Lectures

Course Description

The Digispark is a microcontroller based on Attiny85 development board. It is similar to Arduino but smaller and more powerful. you can purchased it from digistump its specification are: Support for the Arduino IDE 1.0+ (OSX/Win/Linux) Power via USB or External Source - 5v or 7-35v (12v or less recommended, automatic selection) On-board 500ma 5V Regulator Built-in USB 6 I/O Pins (2 are used for USB only if your program actively communicates over USB, otherwise you can use all 6 even if you are programming via USB) 8k Flash Memory (about 6k after bootloader) I2C and SPI (vis USI) PWM on 3 pins (more possible with Software PWM) ADC on 4 pins Power LED and Test/Status LED